ProjectorSupport - ViewSonic Australia

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below. a. 3D ready projector b. 3D Blu-Ray player c. 3D content d. Active 3D glasses 144Hz e. HDMI Premium Certificate cable 2. Here is the playback process below. a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable. b. T...

How to make the screen fit my projector's display area?

Please refer to this FAQ: How to solve the overscan problem with my monitor?

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

How to clean the projector lens

To clean the projector lens, do the following: Use a canister of compressed air to remove dust. If the lens is still not clean, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently wipe the surface. CAUTION: Never rub the lens with abrasive materials

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page. <Note> It is recommended that you use an authentic ViewSonic replacement lamp.

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu. 2.Check the light source level and make sure it’s on Full or Normal. 3.Turn off or reduce environmental luminance where the projector is in use.

How to purchase a lens for a projector

Or browse to your projector model in the Projector Accessories section of the ViewSonic Store. If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...

What is the maximum resolution for the projector.

To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...