This is normal operation. It is either a temporary cooling phase (3–5 mins) or a result of the Network Standby feature being enabled. Detailed Explanation: 1. Cooling Down Period Behavior: The fan remains on for 90 seconds to 5 minutes after pressing the power off button. Purpose: To dissipate residual heat from the lamp. Do not unplug ...
To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...
Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
Please refer to this FAQ: How to solve the overscan problem with my monitor?
1.Please increase the Contrast and Brightness in OSD menu. 2.Check the light source level and make sure it’s on Full or Normal. 3.Turn off or reduce environmental luminance where the projector is in use.
Most fan noise issues are related to settings or ventilation. Check the High Altitude Mode and ensure the vents are clear before considering repair. Troubleshooting Steps: Verify Device Specs: If you own a fanless portable model and hear strange noises, contact support immediately as there are no moving parts intended to make sound....
Please refer to this FAQ.
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
To clean the projector lens, do the following: Use a canister of compressed air to remove dust. If the lens is still not clean, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently wipe the surface. CAUTION: Never rub the lens with abrasive materials
联系我们