Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...
Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...
Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
1. Ensure that your monitor has built-in speakers. You can check it on Product's website page -> Specification -> Audio. 2. Check the cable connection: a. Make sure the connection is secured. b. Re-plug or try another HDMI (Premium) certificated cable in direct connection. c. If using a VGA cable, ensure the audio cable is connected ...
Certain menu settings are locked based on the current input signal or preset picture mode to maintain optimal image quality. Verify Input Source: When using digital connections (HDMI, DisplayPort), options like Phase or Horizontal Position are automatically optimized and locked. These are only available for manual adjustment under a VGA (a...
Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card 2. Make sure your devi...
Check all cable connections, verify the LED indicator on the AC adapter, and test a different wall outlet. Verify Connections: Ensure the power cord is firmly seated in the AC adapter "brick" and the plug is fully inserted into the wall outlet. Check Adapter LED: Look for a small light on the adapter unit. LED On: The adapter is re...
Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...
Use the "Reset All Settings" or "Factory Reset" option in the menu to revert all configurations to their original state. Standard Projector Menu: Press [Menu] on your remote. Navigate to [System Setting: Advanced]. Select [Reset All Settings] and confirm. Smart Projector Menu (M-series / X-series): Go to the Home Screen...
1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...
联系我们