1.Please increase the Contrast and Brightness in OSD menu. 2.Check the light source level and make sure it’s on Full or Normal. 3.Turn off or reduce environmental luminance where the projector is in use.
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
Most fan noise issues are related to settings or ventilation. Check the High Altitude Mode and ensure the vents are clear before considering repair. Troubleshooting Steps: Verify Device Specs: If you own a fanless portable model and hear strange noises, contact support immediately as there are no moving parts intended to make sound....
The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page. <Note> It is recommended that you use an authentic ViewSonic replacement lamp.
Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
If the external monitor/ projector is not automatically detected and displaying an image, you will need to use a function key to enable or activate the function. Laptop manufacturers have different methods to activate an external monitor. Refer to the laptop's user guide/manual or the manufacturer for instructions to activate the video port for...
This is normal operation. It is either a temporary cooling phase (3–5 mins) or a result of the Network Standby feature being enabled. Detailed Explanation: 1. Cooling Down Period Behavior: The fan remains on for 90 seconds to 5 minutes after pressing the power off button. Purpose: To dissipate residual heat from the lamp. Do not unplug ...
Adjust the image size by changing the "Throw Distance," rotating the "Zoom Ring," or using the "Digital Zoom" setting in the menu. Adjust Throw Distance (Physical): This is the most effective method. Move the projector further from the screen for a larger image, and closer for a smaller one. Use the Zoom Ring (Optical): Rotate t...
Or browse to your projector model in the Projector Accessories section of the ViewSonic Store. If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...
联系我们