The Bracket installation order varies from the Wall-mount configuration. Please follow the steps in the respective order for the Floor Stand configuration: Bottom cross beam installed to the left and right supports. Top cross beam installed to the left and right supports. Original mounting bracket removed from the top and reattached to the ...
Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Floor Stand Step 2: Install the System Control Box onto the Floor Stand Step 3: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 4: Install the LED Modules onto the Cabin...
Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Wall-mount brackets Step 2: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 3: Install the System Control Box onto the Floor Stand Step 4: Install the LED Modules onto t...
Answer: If the LED display does not work, but the power supply and other equipment checks are working, it may be caused by a firmware conflict. Please perform mandatory firmware update under this circumstance.
Solution Step 1: Please contact customer service staff to obtain the mandatory firmware update file(s) Step 2: Copy the files to the outermost directory of the USB Step 3: Turn off the power of the LED display and plug in the USB Step 4: Press the power button to turn on the display, and immediately press the Menu butto...
When you find that the edge brightness of the LED module is different from that of the adjacent modules, the following procedure below can be followed in order to resolve the problem. Solution Step 1: Use the USB B-to-A cable and HDMI cable to connect the monitor to the computer, and switch the monitor's input source to HDMI. Step...
Solution Step 1: Select the Settings from the Main Menu Step 2: Select "Upgrade" Step 3: Select "OTA Cloud Server" Step 4: Switch "Auto Updates" to on After turning on the automatic update setting, when the LED display is turning off, the automatic detection of firmware updates will occur. If the latest firm...
After replacement of a particular LED module, brightness may be slightly different than that of other modules. At this point, manual calibration is required. In order to troubleshoot this problem, the following procedure can be followed. Solution Step 1: Use the USB B-to-A cable and HDMI cable to connect the monitor to the computer, ...
Solution This may be an issue related to the settings. Please check the RS232 settings when you encounter this issue: Also, check the RS232 pin definition: Note: RS232 does not need crossover If the user cannot use RS232 or Crestron to remotely turn on the power, refer: "Why can't RS232 be used to Power on/off the dv...
Solution Step 1: Wear anti-static gloves before handling the LED Modules. Step 2: Remove the Vacuum Suction Tool from the box and press its power switch to use it. Please charge it with the included power supply and make sure the vacuum suction tool is kept in a fully charged state. Step 3: Move the Vacuum Suction Tool to t...