Ugrás a fő tartalomra

How to install vSignage License on EP5520 /EP5520T/ EP5540/EP5540T?

Requirements: - USB Flash Drive (FAT32 Formatted): How to format USB flash drive to FAT32 - vSignage license file, available on the Download section of the product's page* 1. Copy the license file (license-production_VSI.PKG) to the root directory of the USB flash drive. 2. Insert the USB flash drive into USB port of the display....

How to update F/W on EP3220/4320/5520?

Upgrade under the factory menu Copy MstarUpgrade.bin in USB and Insert U disk to the USB port Press Input menu and then press 2 5 8 0 to activate factory menu (Fig. 1) Move to “Upgrade Main” item and press OK button to confirm. (Fig. 2) Select “Confirm” to confirm the upgrade (Fig. 3), the system will automatically reboot and start the up...

How to check CDX series , videowall, model RS232 daisy chain working correctly

1. Is it correct of RS232 daisy chain cable ? 2. In OSD menu, General settings -> Eco mode please set to Normal. (If set to Low power standby, the unit can power OFF but can’t power ON) 3. The RS232 daisy chain cable is 2.4mm – 2.4mm

How can I fix EP5520T into floor?

Please refer the attachment. Attachment URL:https://support.viewsonic.com/helpdesk/attachments/33010268005

How can I add other widgets to the Signage manager software?

You can refer below steps to use other widgets.

Which network ports should be opened for Signage Manager and media players?

 To ensure Signage Manager can discover and control players over a Local Area Network (LAN), please ensure that TCP 80, 8080, 443, and UDP 1900 are opened in your firewall settings. Port Configuration Table: Port TCP UDP Description 80 TCP Hypertext Transfer Protocol (HTTP), main communication port with legacy play...

How to prevent image quality loss when exporting from Signage Manager?

While editing content with Signage Manager, it will compress and save photo in lower quality. Please follow below procedures to replace the photo. 1. After finishing editing in Signage Manager, choosing “Export to USB”. 2. Open “File Explorer” and locate USB drive in SMIL/media folder. 3. Copy original photos to this folder and...

How to get back to the dashboard while content is playing via vSignage?

There are two methods to get back to the dashboard. 1. Press up button on the remote control to go to the dashboard 2. Connected to a mouse, directly press and hold anyone of the corner area, after successfully triggering the countdown, the corner area will flash in reverse (as shown in the figure). It will exit after ten seconds. 

Does the EP5520 support WPA2-Enterprise authentication and certificate installation?

Yes. The capability for Enterprise authentication depends on the hardware specifications of the installed Wi-Fi module/dongle and its firmware compatibility. Instructions & Steps: Hardware Verification: Supported Wi-Fi security protocols are dictated by the Wi-Fi Module/Dongle. Please ensure your module supports 802.1X / WPA2-Enterprise ...

ViewSonic CDE30 Series Power Save Modes: Which Mode Should I Use?

ViewSonic CDE30 Series power save modes: Which mode should i use? There are four Power Save modes to choose from and knowing which one to use depends on the application. For this scenario we will cover digital signage, information and monitoring systems and meeting rooms where always-on, wake up on active signal and fast boot time is a must...

Kereskedelmi kijelző Támogatás

Digital Signage General Questions Presentation Display

Kapcsolatfelvétel

Kérjük, forduljon közvetlenül hozzánk, ha nem talál válaszokat és megoldásokat a ViewSonic termékeivel kapcsolatban.