Ugrás a fő tartalomra

How to do when my screen doesn’t display native resolution after Windows 10 update?

Windows update may cause some issues with screen resolution setting being lost, Please follow below steps to change the resolution of the screen and check: Type Change screen resolution in the Search box from the desktop  and click   Change screen resolution of the display.   Under Display Resolution select Recommended resolution. A wi...

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page.   <Note> It is recommended that you use an authentic ViewSonic replacement lamp.  

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

Why a black border on the top/bottom or sides of the image from the projector?

Please check below:   1.Plesae refer to the user guide and adjust Aspect ratio with example below.   2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.

Why the image is pixelated from my projector?

Usually this is related to unmatched output resolution setting and content.  For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated.   Please make sure to set recommended resolution by referring to this FAQ.

There is no video when using HDMI port

If you are experiencing problems using HDMI input: Confirm the HDMI input is selected. Plug in the projector first, and then turn on the PC. Replace the HDMI cable, sometimes a cable may go bad. Try another signal type if available for example: VGA, DVI, DisplayPort. Test the projector on a different computer with a HDMI port to make sure...

How to make the screen fit my projector's display area?

Please refer to this FAQ:   How to solve the overscan problem with my monitor?

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

How to solve “Out of range” when connecting PC/laptop to a projector?

Please refer to this FAQ.

How to fix shadows, ghosting, or double images on the projector screen?

Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...

Kivetítő Támogatás

General Questions Technical Documents vRemote Tips & Tricks

Kapcsolatfelvétel

Kérjük, forduljon közvetlenül hozzánk, ha nem talál válaszokat és megoldásokat a ViewSonic termékeivel kapcsolatban.