LED MonitorSupport - ViewSonic Israel

What to do if there is flickering image with my monitor?

Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate. You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE If possible, please connect monitor to another device with different input. If above doesn’t help, please contact ViewSo...

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

What is "Black stabilization" and which level should I choose?

This setting is to provide better picture performance if user’s screen are mostly dark scenes. If no special needs(ex: playing shooting games in dark scenes), it is suggested to turn off.

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

How to fix ghosting, shadowing, or double images on the screen?

Image artifacts are typically caused by signal degradation or interference. Bypass any docking stations and use high-quality certified cables. Bypass Adapters/Docks: Remove any [Docking Stations] or [Video Splitters]. Connect the monitor directly to your PC to test the image quality. Upgrade Cable Quality: For long-distance connections...

Can I turn on 1ms MPRT and FreeSync at the same time?

MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor. Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...