Skip to main content

How to change the monitor refresh rate in Windows?

Adjust your refresh rate via "Advanced Display Settings" for a smoother visual and gaming experience. Open Settings: Right-click on your desktop and select [Display settings]. Advanced Options: Scroll down and click on [Advanced display settings]. Select Refresh Rate: Under the "Choose a refresh rate" dropdown, select the highest ...

How to set a Monitor Webcam as the Primary Camera on macOS?

1. Connect the USB cable to the monitors USB Type B port on the back of the monitor and attach the other end of the cable to an available USB port on the computer. Allow 10-15 seconds for the computer to recognize the external webcam. Please do remember to connect the video signal cable between monitor and computer.   NOTE: This method will ...

What ViewSonic monitors support GeForce Driver G-Sync Enable-Ready?

ViewSonic FreeSync monitors support GeForce Driver G-Sync Enable-Ready.     *Legal Disclaimer for GeForce Driver G-Sync Enable-Ready: Our product follows the Adaptive Sync technology standard adopted by the Video Electronics Standards Association (“VESA”). Our product is compatible with and certified by AMD for AMD’s FreeSync Te...

Why sharpness setting in OSD menu is grey out on my XG2702 and VA2719-2K-SMHD?

When resolution is set in native resolution (1:1), both Sharpness and Overscan option in OSD will be grey out.

What is "Low Input Lag" and which one should I choose?

Input lag means the time difference between when user controls PC and sees the response on monitor.      There is a trade-off to picture/video performance. If no particular demand, it is suggested to set it to off.

Why can't I choose Contrast or Brightness?

Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...

What is the function of power indicator in OSD menu on my monitor?

This is an indicator about power consumption ratio which is affected by some OSD settings change, ex. ECO mode and Brightness. Here's a matrix table about ECO mode and power consumption ratio. ECO mode Power consumption ratio Standard 100% Optimize 85% Conserve 70%

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Should I install MacOS drivers for my monitor?

MacOS does not require monitor drivers when using a ViewSonic monitor. The MacOS will automatically read the EDID information stored in the monitor and use the system information/profiler utility to detect the monitor’s specifications and capabilities.  If you can not get native resolution or refresh rate on the monitor:   Please check if ...

LED Monitor Support

General Questions ColorPro™ (VP series)

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.