Applies to: Manager Devices page; telemetry

Issue

The Total Uptime column on the Devices page does not appear to reset after a display is power-cycled.

What to check first

Work through these steps in order:

1. Note the exact Total Uptime value shown before you power-cycle the device.

2. Record the exact time of the power cycle.

3. After the device reconnects, check the Total Uptime value again and note whether it changed, reset to zero, or stayed the same.

4. Check whether other status fields on the same device, such as Online/Offline status and Last Seen, updated correctly after the power cycle.

Additional notes

Some additional points that may be useful:

• This is a general observation checklist. What Total Uptime measures and what is expected to reset it have not yet been confirmed for this workbook, so this article does not state a root cause.

When to contact Support

Because the definition and reset conditions for the Total Uptime column are not yet confirmed, contact Support with the details below rather than assuming this is an error.

Information to include in your ticket

To help us resolve this faster, please include:

• Device model and serial number

• Firmware version

• Total Uptime value before and after the power cycle

• Exact time of the power cycle

• Screenshot of the Devices page showing the Total Uptime column