Skip to main content

Can I install IFP7550 by Daisy Chain?

Yes, IFP7550 integrated a HDMI output port which is capable of being installed by Daisy Chain. For more details, please refer to the User Guide.

Is there any recommended RS232 software to control IFP7550 by ASCII command?

You may control IFP7550 by Hercules software. Please have "HEX" checkbox unchecked and key in ASCII command with <CR> at the end.

Where can I get more info for suitable slot-in PC with IFP7550?

Please visit product page of IFP7550 in our website and check the section of "RELATED ACCESSORIES" list for details.

Is it possible to select different time zone for date

The default time zone is +8 which can be changed at the initial setting stage by Set up wizard of ViewBoard Launcher. It will be auto sync-up later with internet connection.

What’s the LED backlight life of IFP6550?

The LED backlight life of IFP50 series is 30,000 Hours Min.

The Fluo Yellow colour that shows on IFP5550 is becoming a yellow greenish, how can I do?

You can set color temperature to Cold or drag the dot to right to adjust in Display setting. Please note when you set color temperature to Cold or drag the dot to right to adjust, the blue light also increase.

What the max. external HDD capacity can be supported for IFP7550?

IFP7550 USB port 3.0 supports external HDD up to 4TB. Below models had pass the read/write test. WD: WDBUY0040BBK(4TB) SEAGATS: STDR2000301(2TB) TOSHIBA: HDTC810YR3AA(1TB) SONY: HD-E1(1TB)

How to control IFP via RS232/LAN?

1. Use a RS232 crossover adapter (except: IFP34 series, IFP52-1C series, IFP110) for RS232 control. 2. Make sure to set the communication settings below correctly  3. If you connect from PC, please make sure the com port is correctly chosen.         4. It's recommended to vController to control the Viewboard by RS232.     Please r...

What is the maximum USB cable length for ViewBoard Touch connection?

USB standards have strict physical signal limits. USB 2.0 has a maximum recommended length of 5 meters, while USB 3.0/3.2 is restricted to 2-3 meters. Exceeding these limits causes touch lag, disconnects, or device recognition failure. Technical Specifications: USB Version Data Rate Max Recommended Length Typical Usage USB 2.0 480 Mbp...

What to do if "No Signal" appears on the ViewBoard while connecting an external device (HDMI, USB-C, or PC)?

Step 1: Confirm correct input source on the ViewBoard (IFP) Press the [Input Source] button on the IFP remote or touch menu. Select the matching input (e.g., HDMI1 / USB-C / VGA). Wait 5–10 seconds for the screen to detect input. Step 2: Check your cable and connection type Try another HDMI, USB-C, or VGA cable. If using USB-C...

ViewBoard Support

General Questions Interactive Display Technical Documents

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.