LED MonitorSupport - ViewSonic Philippines

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

How to change the monitor refresh rate in Windows?

Adjust your refresh rate via "Advanced Display Settings" for a smoother visual and gaming experience. Open Settings: Right-click on your desktop and select [Display settings]. Advanced Options: Scroll down and click on [Advanced display settings]. Select Refresh Rate: Under the "Choose a refresh rate" dropdown, select the highest ...

What should I do if there is no video signal when using the HDMI port?

Ensure the monitor is set to the correct HDMI input source and that the cable is firmly connected to the graphics card (GPU) output, not the motherboard. Verify Physical Connections: Unplug and re-seat the HDMI cable at both ends. Note: For desktop PCs, ensure the cable is plugged into the dedicated Graphics Card (GPU) port rather ...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

How to set Landscape and Portrait mode on your monitor?

Change the orientation in your OS Display Settings and ensure your stand supports physical rotation. Use vDisplay Manager for automatic switching. 1. Physical Adjustment: Tilt the screen back and raise the stand to its maximum height before rotating 90 degrees clockwise. 2. Windows 10/11 Setup: Right-click on the desktop and select [Di...

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

How to check graphics card drivers in Windows?

1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

Why does my TD2220 randomly receive touch signal and respond accordingly while exposed to sunlight?

TD2220 is an optical touch monitor which uses two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the sensor...