ProjectorSuport - ViewSonic Romania

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

What to do if there is no sound from the projector’s speakers when connected the PC/laptop to projector?

1. Ensure that your monitor has built-in speakers. You can check it on Product's website page -> Specification -> Audio. 2. Check the cable connection: a. Make sure the connection is secured. b. Re-plug or try another HDMI (Premium) certificated cable in direct connection. c. If using a VGA cable, ensure the audio cable is connected ...

How do I connect external speaker(s) to my projector?

1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...

Want to know about supported picture, video and audio formats

Each product has its own list of compatible video, audio and image formats. The best way to know what file type is specifically supported by your product is to look in the user guide for your particular model.

The image is out of focus

Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

How to mirror iPhone or iPad screen to the projector? (Wired Connection Guide)

Use a USB-C cable or an appropriate HDMI adapter for a stable, low-latency wired connection. USB-C Direct Connection (Recommended): Use a USB-C cable that supports video transmission (using the cable provided with the projector is highly recommended). Connect your device directly to the projector's [USB-C] port. Select [USB-C] a...

Why is my projector fan making an unusual noise?

Most fan noise issues are related to settings or ventilation. Check the High Altitude Mode and ensure the vents are clear before considering repair. Troubleshooting Steps: Verify Device Specs: If you own a fanless portable model and hear strange noises, contact support immediately as there are no moving parts intended to make sound....

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...