LED Monitorการซัพพอร์ต

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

What to do when the screen image is pixelated or blurry?

Blurry images are typically caused by an incorrect resolution or scaling setting. Ensure your computer is set to the monitor's Native Resolution. Troubleshooting Steps: Set to Native Resolution: Windows: Right-click desktop > [Display settings] > [Display resolution]. Choose the one labeled (Recommended). macOS: Go to [System Sett...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion. 1.Adjust setting on the PC/laptop: (1)Set native resolution of monitor in your PC/laptop's Display settings. (2)Change Scaling in Display settings. Use the graphic card software to change ...

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

Should I install Windows 10 drivers for my monitor?

ViewSonic plug and play monitors do not require a proprietary Windows 10 driver to be installed. Instead, Windows 10 will automatically read the EDID information stored in the monitor and install Generic PNP Monitor drivers to enable its full resolution capabilities. The only difference is you will see monitor model name in Device Manag...

How to fix ghosting, shadowing, or double images on the screen?

Image artifacts are typically caused by signal degradation or interference. Bypass any docking stations and use high-quality certified cables. Bypass Adapters/Docks: Remove any [Docking Stations] or [Video Splitters]. Connect the monitor directly to your PC to test the image quality. Upgrade Cable Quality: For long-distance connections...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...