Skip to main content

What is the maximum resolution for the projector.

To locate the maximum or native resolution for a projector, there are a few places this can be found.  We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...

What to do if I can't mirror my screen after I updated the iOS version to iOS14?

Due to iOS14 compatibility issues, please follow below table for solution.   Model Solution X100-4K Install EAirPlay.apk and follow instruction X10-4K Update FW to V1.13 via OTA M2 Update FW to V1.0 via OTA M1+_G2/M1+_V Update FW to V1.04 via OTA M1 mini plus Update FW to V1.02 via OTA SOP URL: https://support.viewsonic.com/hel...

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

How to purchase a lens for a projector

Or browse to your projector model in the Projector Accessories section of the ViewSonic Store.  If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...

How to Install the PS750 Series All-in-One Interactive Projector?

Install the wall mount using the template, mount the projector for alignment, and set up the Laser Curtain module for interactive touch capabilities. Step-by-Step Instructions: Wall Layout: Use the included [Installation Template] to mark the drilling holes on the wall. Ensure the center line matches your projection surface's center. ...

Why are certain options greyed out in the OSD menu?

Certain menu settings are locked based on the current input signal or preset picture mode to maintain optimal image quality. Verify Input Source: When using digital connections (HDMI, DisplayPort), options like Phase or Horizontal Position are automatically optimized and locked. These are only available for manual adjustment under a VGA (a...

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage.   2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

What should I do if the projector remote control is not working?

Replace the batteries and ensure there are no obstructions between the remote and the projector's IR receiver. Replace Batteries: Insert a fresh set of batteries. Low power can cause intermittent operation even if the remote’s indicator light turns on. Clear Obstructions: Ensure the [IR Receiver] on the projector is not blocked by any ...

Projector Підтримка

General Questions Technical Documents vRemote Tips & Tricks

Загальні запитиЗв'яжіться з нами

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.